![]() ![]() This can be achieved by using a heated build platform and applying a layer of adhesive to the bed. When printing with TPU, it is important that the bed adheres well. This makes the Ender 3 S1 Pro with its Sprite Pro extruder ideal for TPU. A direct drive extruder has the motor mounted directly on the hot end.Ī direct drive extruder is useful when 3D printing with TPU because the flexible filament has no chance of getting tangled in the Bowden tube. This setup is often used in 3D printers that have limited space. To prevent this, it is important to use a heated build platform and adjust the print settings accordingly.Ī Bowden extruder has a PVC or PTFE tube running from the extruder motor to the hot end. TPU is a flexible and elastic material that can easily warp. When printing with TPU, it is important to consider the properties of the material. These are the correct Cura settings for the Ender 3 S1 Pro for ABS: This creates excellent adhesion for ABS at the correct temperature. The Ender 3 S1 Pro has a built-in heated bed that has a PEI coating. To improve the adhesion of ABS, it is important to use a print surface that is specifically designed for ABS printing. For the Ender 3 S1 Pro there is a suitable enclosure from Creality.ĪBS is known to be a difficult material to print because of its tendency to warp and peel from the print bed. Therefore, it is important that your printer is properly calibrated and the print bed is heated to the correct temperature before you start printing.Ī 3D printer enclosure is useful when printing with ABS because it helps to maintain a constant temperature and avoid deformation. First layer: 0% cooling, 100% extrusion width, 100% layer heightĪBS printing requires a higher temperature than PLA printing.These are the correct Cura settings for the Ender 3 S1 Pro for PLA: ![]() The first layer should be printed with 0% cooling, 100% extrusion width and 100% layer height. You should also increase the fan speed to ensure good cooling of the print.Ĭura settings for PLA with the Ender 3 S1 Pro require a print temperature of 190-200 ☌, a print bed temperature of 60 ☌, a print speed of 40-60 mm/s and a retraction of 0.8-1.0 mm at 50 mm/s. This is because PLA has a lower melting point than other materials and will not adhere as well to the print bed if it is not heated. When printing with PLA, you should always use a heated print bed. However, the values given by Cura are unsuitable default values which you must still adapt to the Ender 3 S1 Pro.
0 Comments
Leave a Reply. |